You don’t have to call a plumber whenever you have a problem with your Anaheim plumber system. There are some things that you can repair on your own.
Most of the fixes are tasks that will only need basic skills and tools.
Replacing a Shutoff Valve
You have to first determine your valve’s connection style. You will either have a threaded valve, compression valve or a sweat valve. Turn off the water supply, disconnect the valve from the supply tube and replace it. Connect the valve and let the water run through to flush out any air trapped inside.
Fixing a Water Softener
Open the softener and remove all the salt sediments at the bottom of the tank. Pour in some hot water to dissolve whatever remains of the salt before you restart the system. Into the brine well tube, pour dilute resin cleaner. Rinse the air check valve with warm water. Remove and clean the filter screen and the venture assembly unit.
Fixing a Leaking Water Heater
You need to keep a close eye on the mineral deposits and temperature settings. If your system is discharging water, the T&P (temperature and pressure relief valve) has a problem, or perhaps your heater is working under intense pressure and temperature. Clean minerals that might have clogged the system, especially if you use well water.
Fixing a Clogged Toilet
This is one of the simplest DIY jobs. Insert a toilet plunger with the flange pulled out. This should help you get a good seal. Pump in and out repeatedly, making sure there is enough water in the bowl. In case this does not work for you, you might have to use a toilet snake.
Unclogging a Bathtub Drain without Chemicals
Remove the stopper first. You could have a set screw stopper, levered stopper or push/lock drain stopper. Having removed the stopper, curve a coil around a coat hanger to form a hook. Insert the hook down the drain and pull out whatever debris you find inside.
Stopping a Running Toilet
Inspect the fill tube to ensure that it pushes water into the overflow tube. Next, look at the float. Adjust it so that you have the right water level. Keep adjusting it until you have water shutting off at the right level. Adjust the flush chain, leaving around an inch so that you don’t have water overflowing. You might also need to change the flapper.
Removing a Stuck Cleanout Plug
Clean any debris around the wood surrounding the plugs, including cobwebs. While shielding the wood with a baking pan, use a soldering torch to heat the plug and fitting. Apply just enough heat. Use a hacksaw to cut the old section out. It is advisable to not interfere with the remaining replacement parts, or you will have bigger plumber Anaheim CA problems.
Finding and Repairing Hidden Plumbing Leaks
The first thing you have to do is try and find the source of the leak. In most cases, you will find it either in the supply tank, a connection joint or along the pipes. In case the connections are loose, tightening them might solve the problem.
Stopping Leaks in Plumbing Joints
Get Teflon tape and wrap it around the leaking joint. Apply some lubricant around the compression joints – the brass ring and ferrule. Ensure you choose supply tubes that are flexible. Chrome or solid copper lines might be difficult to work with unless you have experience.
Repairing a Leaking Faucet
Study the faucet and figure out where the leak is coming from. Turn off the water supply. When removing the faucet parts, focus on the order so that you can return them in the right way. Clean out any debris in the pipes, connect the water, flush the pipes clean, and then reconnect them.